Getting Your Voltage Right in Glass Annealing If you’ve ever managed a continuous glass annealing line, you know the drill. You need those thermal...

Dealing with “Cold Spots” in Long Glass Tunnel Kilns Most infrared lamps stop at 1.5 meters. If you’re running a long tunnel kiln,...

Stop Fighting Your Glass Annealing Setup Anyone who’s spent time with scientific glass knows the drill. You need those thermal gradients to be spot...

Getting Your Glass Annealing Right: It’s All About the Spectrum If you’re working with specialized glass additives, you’ve probably noticed that...

Selling a lamp is the easy part. Any catalog can do that. But getting the thermal profile exactly right for Spectacle glass annealing? That’s where...

Why we’d rather come to your shop than just mail you a lamp Let’s be honest. Buying a heating lamp based on a spec sheet almost never fixes a...

Getting Low-E Glass to Bend Without the Headaches If you’ve ever tried to heat wide-format Low-E glass, you know it’s a completely...

Cutting through ultra-thick glass is basically a wrestling match with the material. If you’ve ever tried to run a cutting wheel through thick...

Stop Wasting Power on Your Fiberglass Annealing Let’s be honest: traditional fiberglass annealing is a power hog. I’ve walked through plenty of...

Getting Your Glass Heat Just Right If you’ve ever dealt with tempered glass, you know the nightmare of hot spots. One tiny uneven patch of heat and...

Stop the Chips: Why We Preheat Our Glass Glass is stubborn. It’s brittle, and when you drive a cutting wheel into a cold sheet, you aren’t just...

Millisecond Curing for Low-E Coatings: Speed That Saves the Film We build infrared oven lamps for one place: the glass finishing line. Specifically,...

Introduction You know that frustration. You’re running a glass coating line, and you watch as those mirrors come out—streaked, ruined. It’s usually...

Out on the line, glass doesn’t wait around. A furnace that drags on heat-up drags the whole tempering or lamination cycle with it. And when the...

On the line, annealing is where the money is made—or lost. If the lehr profile is off, you trap thermal stress in the glass. That shows up later as...

On the jewelry glass line, annealing is where you make or break yield. Under-soaked parts hold latent thermal stress and crack later—sometimes in...

On the line, glass doesn’t forgive uneven heat. One hot spot and you’re chasing thermal stress fractures. A cold zone and the bend falls out of...

The line is moving. You hear the conveyor hum, the pneumatics cycle, and then the alarm slices through it—another reject off the tempering line,...